Belt conveying

Belt conveyors move most of the world's bulk materials, and on long overland routes most of their power is lost to friction. We measure where that energy goes and design systems that waste less of it.

Much of the energy goes into the rubber belt cover deforming as it passes over each idler (indentation rolling resistance), and into friction in the idlers' bearings and seals. We measure these losses on a dedicated test rig at NIER and use the results to refine the models designers use to size conveyors and drives. We also study what happens at the drive: how pulley lagging grips, wears and fatigues, and when the belt starts to slip.

Problems we can help with

  • Conveyor power draw is higher than the design predicted
  • Belts, idlers or pulley lagging wearing out faster than expected
  • Drive pulleys slipping, particularly at start-up or in wet conditions
  • Choosing a belt compound and idler size for a long overland conveyor
  • Comparing a conventional conveyor with lower-energy alternatives for a new route

If the answer needs new research, talk to us about a project. For routine testing or design work, TUNRA Bulk Solids is usually the quicker route.

Current research

  • Drive pulley lagging: friction, wear and fatigue of lagging, funded by an ARC Linkage project awarded in 2025.
  • Idler rollers: the effect of roller diameter, bearings, seals and lubricants on rotating and rolling resistance.

In industry

Selected publications

Researchers

Professor Craig Wheeler, Dr Peter Robinson, Dr Michael Carr, Dr Jason Willis

Student projects

  • Angus Foley: The development of a dynamic analysis model for the Rail-Running Conveyor system
  • Ashleigh Kirkland: Optimisation of conveyor systems based on rates of wear